lancashire – Tiling Tips – Tips and Information About Tiling

Italian Marble Kitchen Marble Renovated in Bamber Bridge

15th May 2021 Reese Mackie 0 Comments Bamber Bridge, Classic Floor, Floor Tiles, Kitchen Tile Renovation, lancashire, Marble Floor Renovation, marble tile cleaning, Preston, regrouting, Sealing Marble

The tiles shown in the photographs below are classic distressed Black and White Italian Marble installed in the kitchen of a property in Bamber Bridge which is South of Preston. Some of the tiles had an issue with loose grout which I suspect was due to the suspended wooden floor and a small amount of movement had resulted in the grout cracking. Ideally more support would be needed under the floor to prevent this, in the meantime however I recommended removing the grout and replacing with a flexible grout product that could cope with the movement. The tiles also needed a clean, polish and reseal so it made sense to address the issue with the grout as part of the work. Cleaning and Re-grouting a Marble Tiled Kitchen Floor Working as a two-man team we started by cleaning the floor with a set of diamond burnishing pads starting with a coarse 400-grit, followed by 800 and 1500 grit. Water was used to lubricate the process and the floor was rinsed with water between pads with the fine slurry generated by the process extracted using a wet vacuum. These pads remove ingrained dirt and then slowly refine the appearance of the Marble building up its polished appearance in the process. The next step was to rake out all the grout which as discussed was compromised and needed

Restoration of Marble Tiles

6th April 2017 Reese Mackie 0 Comments cleaning services, kendal, lancashire, marble tile cleaning, Tile Cleaning

We were recently asked to look at a polished Marble Tile installed in the floor of a house in Kendal, Cumbria. They were recently fitted but the local Tiler had struggled to get the sheen right on the surface of the Marble, in fact the sealer he had used was badly smeared in some places and needed to come off. To strip off the sealer we used with a Red diamond encrusted burnishing pad fitted to a rotary machine and then rinsed the floor with water which we then removed using a wet and dry Vax machine. We then used other pads in the burnishing system process to clean and polish the Marble floor until we had a nice overall sheen. We finished off the floor with a coat of Tile Doctor Ultra-Seal, which is a premium, no-sheen, natural-look penetrating sealer formulated to provide maximum stain protection. Source: Polishing Marble Tiled Floor in Kendal, Cumrbia