Restoring Victorian Hallway Tiles after Building Works
These photographs are of a Victorian tiled hallway at a house in Hampton, Middlesex which is South West suburb of London. The tiles had suffered during the completion of extensive building works and as you can see from the picture below, the tiles were looking dull and had lost their vibrancy.
On top of that the floor was heavily soiled with plaster dust as well as general soiling from wear and it had not been cleaned or sealed for nearly eight years. Victorian tiles are very hard wearing however and I knew I could put new life into the floor by giving them a good deep clean and re-seal.
Cleaning Victorian Hallway Tiles
To get the tiles clean and remove unwanted coatings we applied a 50/50 combination of Tile Doctor Pro-Clean and Tile Doctor Remove and Go.
This combination of products is effective at breaking down old sealers and coatings as well as cleaning the soil away from the tile.
The products were left to soak in for ten minutes before using a heavy-duty machine fitted with a scrubbing pad to work the solution into the pores of the tile. This did the trick and the soil and products were then flushed away using our special flushing tool which fires a jet of water onto the tile whilst extracting it at the same time with a vacuum (so no mess!)
Sealing Victorian Tiles
After allowing the tiles to dry overnight with some heating on, the floor was ready the next morning to accept a fresh sealer. Our customer wanted to have a sheen finish so we opted for Tile Doctor Seal and Go which works really well on Victorian tiles. Seven coats were applied to the floor before it was completely sealed and protected.
As well as improving the appearance of the tiles new sealer will also make cleaning much easier for the customer.
Source: Victorian Tile and Grout Cleaning Service in Middlesex