Restoring the Finish in an Opulent Marble Bathroom
You may recall a job I wrote about earlier in the year concerning a Limestone tiled floor in Westminster well I’m please to say the owner of that property was so pleased with my workmanship that I was asked back to maintain the Marble tiled bathroom which included a sink unit.
Maintaining Marble Tiles
Normally with polished stone it’s necessary to burnish the floor however in this case the tiles were in good condition with no scratches in the polish, there were a few spots and marks on the tile that needed to come off and they had lost some shine however a full burnish would not be necessary.
 |
 |
To remove the spots and marks I treated them first with a solution of Tile Doctor Pro-Clean diluted 4:1 with hot water. I then scrubbed them using a red buffing pad on my rotary floor machine, which took the marks away from the stone. Next I used a medium burnishing pad with a little water and followed with the fine pad and finally the ultra-fine burnishing pad to restore the shine and polish. I offered to build-up a durable polish with Tile Doctor Shine Powder however the owner was happy with the finish that had been achieved.
 |
 |
Sealing Marble Tiles
Once the tiles were dry I sealed them using Tile Doctor Colour Grow which is an impregnating sealer which occupies the pores of the stone and also enhances its natural colours in the process.
 |
 |
Once the floor had been done I carried out the same process on the Marble sink unit using small six inch pads with a hand polisher. All went well and as you can see from the water bubble test in the photograph below the floor is now fully sealed however there is more work to be done elsewhere in the house and the owner has now booked me in to clean all of the carpets.
