Refreshing a Travertine Tiled Shower Cubicle
This is a follow-up post from last week where I detailed the restoration of a beautiful polished travertine floor that had been installed on most of the ground floor and bathroom at a property in Newton Heath. After cleaning, polishing and sealing the floor tiles the owners asked if I could apply the same treatment to their Travertine tiled shower cubicle which was not looking its best and had become stained over time.
Cleaning Travertine Shower Wall Tiles
First I successfully cleaned the grout with a medium dilution of Tile Doctor Pro-Clean scrubbed into the wall grout with a special stiff grout brush, the tiles were then rinsed with water and the process repeated until I was satisfied with the result.
To clean the Travertine wall tiles I used the same Diamond pad system as I did on floor, starting from 400 grit and moving up to 3000 grit pads lubricated with a little water, the only difference this time was that I used smaller six inch pads fitter to a hand held burnishing machine.
Sealing Travertine Shower Wall Tiles
After I completed all the cleaning and the tiles had dried I proceeded to seal them with Tile Doctor Colour Grow sealer, this is the same sealer that I used on the floor and the excess was polished off with cotton cloths.
The last remaining step was to strip out the silicone sealant strip from around the base of the shower cubicle and replace with new. I used high quality anti mould silicone sealant that left nice lines and fresh look.
Needless to say, that customer was very happy with the work carried out on the floor and shower cubicle and recommended me to his neighbour straight away.
Source: Travertine Tile Renovation and Restoration Service in Greater Manchester