How to Lay Seamless Travertine Marble Tile Successfully
Laying a travertine marble tile floor seamlessly (i.e., without grout) is a skill that you can easily develop. Only a little bit of knowledge, a few tools, patience, and diligence are required to complete this job successfully.
There is no need to be intimated by this type of project. After all, if the ancient Romans and Greeks were able to do it, why can’t you?
There are only a few things besides the tile that are required to complete this kind of home improvement job: a thin-set mortar, notched trowel, a level, and a soft rubber mallet. The difficulty level of this do-it-yourself project is considered to be medium or moderate; however,that is due to the fact that some tiles may need to be reset in order to ensure a level plane across the floor.
It Is All In the Preparation
Preparation is key to a seamless installation of this type of natural stone. Ninety-nine percent of all successful home improvement jobs start with proper prepping of the working surface. For any surface–whether it be a floor, countertop, or wall, make the working area as level as possible before you do anything else. Check your work with a level prior to any travertine tile installation.
Application of Thinset On Flooring – Kick It Up A Notch
Working from the middle of the room, use the trowel’s notched edge to apply an even coat of thinset mortar to the flooring surface, spreading it evenly in the area where you will set the travertine. Take your time when doing this in order to avoid ridges and/or air pockets which may cause the tile to settle improperly.
Application of Thinset On Back of Tile – Flat Is Beautiful
Now it is time to use the trowel’s flat side to apply a skim coat thinset to the back of the travertine marble tile. Ensure it is evenly distributed throughout, taking care to coat the edges of the tile.
Apply the Tile With Gentle But Firm Persuasion
Set the tile in place on the floor, applying pressure, and moving it back and forth in all directions to form a good bond and to eliminate any unforeseen trapped air bubbles/pockets.
Then it is time to set the second tile next to the first, lining up the corners, and moving that tile back and forth as you did the first one.
Make sure the tiles are the same height. Using a soft rubber mallet, tap gently on the second travertine marble tile until it abuts the first tile. There should be a tight fit with no gaps.
Keep a Level Head and Get a Level Floor
Lay a level on the tile floor to ensure that tiles are flat and flush. If a tile is too low, remove the tile and add more thinset on the floor. If the opposite is true and the tile is too high, pry up the travertine and remove excessive thinset. Either way, there is a remedy so you can get a level floor by keeping a level head and doing what needs to be done to get the perfectly seamless travertine marble tile floor.